After you have successfully installed and configured APF (Advanced Policy Firewall) on your dedicated server, you can optionally configure AntiDOS for DOS protection. Once done, you will need to start and run APF on your server, and below, you will find the steps necessary to do so.

Starting APF on Your Web Server

1. Edit /etc/apf/allow_hosts.rules and enter your IP (not a mandatory step, but will avoid being locked out of the server)

2. Start the firewall by executing the command apf -s

You should then see,

Development mode enabled!; firewall will flush every 5 minutes.

Now try to access all the services, including mail, ssh, and websites.

3. If you are able to access all the services, then open up /etc/apf/conf.apf, change the DEVEL_MODE=”1″ to read DEVEL_MODE=”0″

Then simply restart the firewall by executing apf –r and you should be done!

4. As a last step, you should execute the command “chkconfig –list apf” and confirm whether you see a similar entry like

apf             0: off   1: off   2: off   3: on    4: on    5: on    6: off

You should see it, exactly similar to above, but in case it is not like that, execute chkconfig –level 345 apf on

Congratulations, you have successfully installed APF! If these tutorials were over your head or you feel you may have done something erroneously, you ought to purchase Managed Hosting from Lunarpages, as they can offer APF installation completely free with your Managed Hosting purchase.